A new gas tank water heater in a clean garage, held to the wall by two metal seismic straps, an expansion tank on the cold line and a yellow-handled gas shutoff on the flexible connector

Water heater replacement in Roseville, CA

Most water heaters here stand in the garage, and in California every one has to be strapped against an earthquake. When a tank starts leaking into its pan, rumbles, or runs out of hot water too soon, we replace it with a tank, tankless or heat pump model, fit the straps and the expansion tank the code asks for, and pull the permit. The new heater, its gas valve and its water shutoff go on your house map.

  • Two seismic straps, every time
  • Permit pulled and final inspection booked
  • Gas and water shutoffs marked on your map

Or call or text 916-555-0148

Tell us what the water heater is doing

We usually answer the same day. Tell us what you have noticed and roughly when the house was built.

Water spraying or a smell of gas? For gas, leave the house and call PG&E or 911 first. For water, shut the main off, then call or text: 916-555-0148

How a replacement goes

Most tank swaps are done in a day once the permit is in hand.

  1. Read the old one.

    We note the size, fuel and age from the label, check the gas line, the venting and the drain, and mark the shutoffs on your map.

  2. Price the choices.

    Tank, tankless or heat pump, written down side by side, with what each needs at your house.

  3. Install it to code.

    Two seismic straps, the expansion tank, the relief drain to the outside, and the burner raised where the code asks.

  4. Inspect and hand over.

    The city or county inspector signs off, and the new heater goes on your house map.

Book a plumber who maps it first

What the code asks of a garage water heater

Roseville's handout for gas water heaters is a good summary of what an inspector looks for anywhere we work. In a garage, anything that can ignite has to sit at least 18 inches above the floor, which is why so many heaters here stand on a platform. The heater needs two seismic straps. An expansion tank, or a device that does the same job, is required. The relief valve drain runs outside.

When we replace a heater we bring all of that up to date, not just the tank. And because the gas valve and the water shutoff are the two things people look for in a hurry, both are circled on the plan we leave you.

“The tank in our garage started leaking on a Sunday. They put in the new one Monday with both earthquake straps, the expansion tank and the relief line run outside, and pulled the permit. The folder shows where the gas valve is now.”
Priya S. Water heater replacement, Rocklin Sample review,

Book a plumber who maps it first

A gas water heater on a raised platform in a garage, two seismic straps around the tank, an expansion tank on the cold line and birch plywood shelving to one side

Water heater permits, place by place

Every place we work treats a replacement as permitted work. The office changes at the city line.

Where the house isPermit officeWhat it says
RosevilleCity of Roseville BuildingAll water heater installations and replacements need a permit and final inspection
Citrus HeightsCity of Citrus HeightsWater heaters are on the list of projects that need a residential permit
LincolnCity of LincolnWater heater installations need a permit; small jobs can be issued over the counter
Rocklin and FolsomEach city's own building departmentEach issues its own water heater permit; we confirm the paperwork when we book
Granite BayPlacer CountyGranite Bay is unincorporated, so the county issues the permit

Signs the heater is near the end

Any one of these is a reason to plan the replacement rather than wait for the tank to give out.

Water in the pan

A wet drain pan or a puddle at the base usually means the tank itself has started to leak.

Rumbling and popping

Sediment settling in the bottom of the tank makes noise as the burner heats it.

Rust at the fittings

Rust on the inlet or outlet, or rusty hot water only, points to the tank.

Missing straps

No straps, one strap, or straps hanging loose. California law asks for bracing on every residential heater.

You deal with Wes, from the label on the old tank to the final inspection

Wes Lindqvist, owner of Birch & Brass Plumbing, holding a clipboard with a hand-drawn house plan in front of a Roseville ranch house

Wes Lindqvist, owner and licensed plumbing contractor

Wes walks the house with you, draws the map as he goes and writes the price before any work starts. You deal with him from the first call to the folder in your kitchen drawer.

Book a water heater visit

We usually answer the same day. Tell us what you have noticed and roughly when the house was built.

Water spraying or a smell of gas? For gas, leave the house and call PG&E or 911 first. For water, shut the main off, then call or text: 916-555-0148

Water heater questions we hear most

Do I need a permit to replace a water heater in Roseville?

Yes. The City of Roseville's handout says all water heater installations and replacements require a permit and final inspection, and lists water heater replacement among its quick online residential permits. Citrus Heights and Lincoln list water heaters among their permit projects too, and Rocklin, Folsom and Placer County, for Granite Bay, each issue their own. We pull it and book the inspection.

Why does the water heater have to be strapped?

California Health and Safety Code section 19211 requires every new, replacement and existing residential water heater to be braced, anchored or strapped so it cannot fall or shift in an earthquake. Roseville's handout spells out the plumbing code rule: at least two straps, one in the top third and one in the bottom third, with the bottom strap at least 4 inches above the controls.

I am selling my house. Does the water heater matter?

It does. Under section 19211 a seller has to certify in writing to the buyer that the water heater is braced, anchored or strapped as the law requires. That can go in the usual sale papers, such as the transfer disclosure statement. If the straps are missing or loose, it is a short visit to fix.

Is a heat pump water heater worth it here?

It depends on your electric utility. If you are a SMUD customer, as many homes in Citrus Heights and Folsom are, SMUD offers up to a $4,000 rebate on qualifying heat pump water heaters, subject to funding, submitted by a participating contractor, with a permitted, inspected installation and a thermostatic mixing valve. Roseville Electric's current rebate page does not list a heat pump water heater rebate. We check what applies to your address.

Why does the new heater need an expansion tank?

When water heats, it expands. With nowhere to go, that extra volume raises the pressure in the house's lines. Roseville's water heater handout requires an expansion tank or a similar device, along with a relief valve drain that runs outside and ends 6 to 24 inches above the ground, pointing down.

Call or text 916-555-0148

A 1970s ranch house on a quiet Roseville street at dusk, warm light in the windows, a valley oak in silhouette and a white work van at the curb

Water heater leaking or out of hot water? Tell us.

A photo of the label on the tank helps us bring the right parts. If you smell gas near it, leave the house and call PG&E or 911 first.

Book a plumber who maps it first

We usually answer the same day. Tell us what you have noticed and roughly when the house was built.

Water spraying or a smell of gas? For gas, leave the house and call PG&E or 911 first. For water, shut the main off, then call or text: 916-555-0148

Call or text 916-555-0148